Finishing Accessories

Bushings Designed by Hold Fast ™ to prevent glue bonding your blank to your bushings while applying a CA finish! (Bushings come 4 to a pack)

You will want to turn your pen first with your regular bushings then replace with these bushings before applying your CA finish.

150 Grit seems to be the one roll in your set that you go through first & fastest.
Here is a single replacement roll in the 150 Grit for the Abrasive Rolls - 5 Piece Set. You don't have to purchase an entire set just to get the 150 grit.

Four head trimmer (3/4")

To see a video on making your own trim sleeves 

Cutting shafts fit into a drill, drill press or drill chuck on the lathe. The shaft will keep the cutting head at a 90 degree angle to the tube in your blank. Please note that the shaft of a pen mill/barrel trimmer is not for cleaning glue out of the inside of the tube. You should always clean out the inside of your tube before using this tool. Failure to do so may cause your tube to spin loose inside the barrel.

 
Complete system includes:
7mm, 8mm, 3/8", and 10mm pilot shafts 3/4" squaring cutter, allen wrench and set screw.

Each Grit is 3/4" wide by 15' Long. Cut what you need and use it over and over. This roll will last a very long time. Far superior to plain cloth back sandpaper.

Click On Image For Larger View

Each Grit is 2-2/4" wide x 30' Long

Using Abranet, dust is removed from the space between the abrasive and the sanded surface, which means that the abrasive grains are cutting the surface more efficiently.

We use Abranet® When making the wooden tubes for our inlays. We can sand around 200 blanks with one sheet as opposed to less than twenty-five with conventional cloth backed sand paper.

There are 5 grits in the set. Two sheets of each grit are in each set.

Using Abranet, dust is removed from the space between the abrasive and the sanded surface, which means that the abrasive grains are cutting the surface more efficiently.

We use Abranet® When making the wooden tubes for our inlays. We can sand around 200 blanks with one sheet as opposed to less than twenty-five with conventional cloth backed sand paper.

Click on image for larger view

2-3/4"x5" Single Sheet of ABRANET®

Using Abranet, dust is removed from the space between the abrasive and the sanded surface, which means that the abrasive grains are cutting the surface more efficiently.

We use Abranet® When making the wooden tubes for our inlays. We can sand around 200 blanks with one sheet as opposed to less than twenty-five with conventional cloth backed sand paper.

Five Grit Sanding Rolls, J Cloth Backed Sandpaper. Rolls are 1" wide by 20' Long.
Grits are: 150, 240, 320, 400 and 600

Click on image for larger view

CA Wood Finish System Gloss Polish in 2-oz. size

CA Wood Finish  Satin Polish in 2-oz size